Descriptions:
The KELILONG tester is a conductivity tester to measure water concentrations. It is used in water treatment,
chemical dilution, industrial waste or drinking water where water quality control is required.
It is widely used in industrial boiler, cooling towers, chemical mixing where water concentration is monitored.
The best tool technician on the go!
TDS tester is design for ruggedness and accuracy. TDS is measured in water processing and industrial water
treatment and control. The conversion factor from conductivity is the factor of 2 which is an industrial standard.
It is the best gauge to perform QC and on-site checks in boilers, cooling towers, chemical dilution for waste disposal.
One-Touch Calibration
On activation, the tester calibrates the end-point automatically at prescribed standard solution.
Hold Function
Able to freeze display for ease of reading and recording.
Low battery alert Function
The meter is supplied with BEPS (Battery Error Preventing System) which avoids any erroneous reading due to low battery level, by switching the meter off.
LCD with backlit Function
Easy reading in a dark environmental
|
Technology Parameters >>
|
|
Model
|
KL-988
|
KL-989
|
KL-982
|
KL-983
|
|
Measuring range
|
0~1999μS/cm
|
0~19.99ms/cm
|
0~1999mg/L(ppm)
|
0~19.99g/L(ppt)
|
|
Accuracy
|
±2¨GF·S
|
±2¨GF·S
|
±2¨GF·S
|
±2¨GF·S
|
|
Resolution
|
1μS/cm
|
0.01ms/cm
|
1mg/L(ppm)
|
0.01g/L(ppt)
|
|
Display
|
4-digital LCD with Backlit
|
|
Automatic Temperature Compensation
|
0¡æ~50¡æ
|
|
Environment
|
Temperature:0¡æ~50¡æ; Humidity:≤95¨G
|
|
Power Supply
|
4×1.5V(AG13)
|
|
Dimensions
|
170mm×33mm×20mm
|
|
Weight
|
69g
|
